Standalone Debug Options
------------------------

--show-gateway args
  (Standalone) Show current IPv4 and IPv6 default gateway and interface
  towards the gateway (if the protocol in question is enabled).

  Valid syntax:
  ::

     --show-gateway
     --show-gateway IPv6-target

  If an IPv6 target address is passed as argument, the IPv6 route for this
  host is reported.


Advanced Expert Options
-----------------------
These are options only required when special tweaking is needed, often
used when debugging or testing out special usage scenarios.

--hash-size args
  Set the size of the real address hash table to ``r`` and the virtual
  address table to ``v``.

  Valid syntax:
  ::

     hash-size r v

  By default, both tables are sized at 256 buckets.

--bcast-buffers n
  Allocate ``n`` buffers for broadcast datagrams (default :code:`256`).

--persist-local-ip
  Preserve initially resolved local IP address and port number across
  ``SIGUSR1`` or ``--ping-restart`` restarts.

--persist-remote-ip
  Preserve most recently authenticated remote IP address and port number
  across :code:`SIGUSR1` or ``--ping-restart`` restarts.

--prng args
  *(Advanced)* Change the PRNG (Pseudo-random number generator) parameters

  Valid syntaxes:
  ::

     prng alg
     prng alg nsl

  Changes the PRNG to use digest algorithm **alg** (default :code:`sha1`),
  and set ``nsl`` (default :code:`16`) to the size in bytes of the nonce
  secret length (between 16 and 64).

  Set ``alg`` to :code:`none` to disable the PRNG and use the OpenSSL
  RAND\_bytes function instead for all of OpenVPN's pseudo-random number
  needs.

--rcvbuf size
  Set the TCP/UDP socket receive buffer size. Defaults to operating system
  default.

--shaper n
  Limit bandwidth of outgoing tunnel data to ``n`` bytes per second on the
  TCP/UDP port. Note that this will only work if mode is set to
  :code:`p2p`.  If you want to limit the bandwidth in both directions, use
  this option on both peers.

  OpenVPN uses the following algorithm to implement traffic shaping: Given
  a shaper rate of ``n`` bytes per second, after a datagram write of ``b``
  bytes is queued on the TCP/UDP port, wait a minimum of ``(b / n)``
  seconds before queuing the next write.

  It should be noted that OpenVPN supports multiple tunnels between the
  same two peers, allowing you to construct full-speed and reduced
  bandwidth tunnels at the same time, routing low-priority data such as
  off-site backups over the reduced bandwidth tunnel, and other data over
  the full-speed tunnel.

  Also note that for low bandwidth tunnels (under 1000 bytes per second),
  you should probably use lower MTU values as well (see above), otherwise
  the packet latency will grow so large as to trigger timeouts in the TLS
  layer and TCP connections running over the tunnel.

  OpenVPN allows ``n`` to be between 100 bytes/sec and 100 Mbytes/sec.

--sndbuf size
  Set the TCP/UDP socket send buffer size. Defaults to operating system
  default.

--tcp-queue-limit n
  Maximum number of output packets queued before TCP (default :code:`64`).

  When OpenVPN is tunneling data from a TUN/TAP device to a remote client
  over a TCP connection, it is possible that the TUN/TAP device might
  produce data at a faster rate than the TCP connection can support. When
  the number of output packets queued before sending to the TCP socket
  reaches this limit for a given client connection, OpenVPN will start to
  drop outgoing packets directed at this client.

--txqueuelen n
  *(Linux only)* Set the TX queue length on the TUN/TAP interface.
  Currently defaults to operating system default.

